What's new

General VU+ Receiver Discussion hotkey script to change channel?

SirV

Member
Messages
5
Joined
Jan 20, 2017
Reaction score
1
Points
3
I'm trying to create a script to change channel and assign it to a key. I can do the change channel bit but it opens the EPG and shows the script running, switches channel but keeps the EPG open.

How do I close the EPG?
 

Ten Below

SuperTux
Staff member
Admin
Moderator
Messages
7,935
Joined
Sep 9, 2014
Reaction score
7,765
Points
628
I'm trying to create a script to change channel and assign it to a key. I can do the change channel bit but it opens the EPG and shows the script running, switches channel but keeps the EPG open.

How do I close the EPG?
Which image are you using as the hotkey feature is included with most?
 

SirV

Member
Messages
5
Joined
Jan 20, 2017
Reaction score
1
Points
3
I have the hotkey feature but I can't seem to set a hotkey to zap a channel, the only way I can see to do it is via getting the hotkey to run a shell script.
 

Ten Below

SuperTux
Staff member
Admin
Moderator
Messages
7,935
Joined
Sep 9, 2014
Reaction score
7,765
Points
628
I have the hotkey feature but I can't seem to set a hotkey to zap a channel, the only way I can see to do it is via getting the hotkey to run a shell script.
Reading your first post again it sounds like you have set a button to zap but what you need to set it to is zap & exit.
 

SirV

Member
Messages
5
Joined
Jan 20, 2017
Reaction score
1
Points
3
yes correct so it zaps but then stays on this screen with the script results
Screen Shot 2017-10-07 at 11.01.39.png

I don't see an exit option to add on the hotkey setup screen, so was tryig to add soemhting to the shell script but not sure what it needs to be
 
Thread starter Similar threads Forum Replies Date
Matt Solo VU+ News & Discussion 3

Top Bottom