What's new

OScam Issue with 13E and satellite.xml

borderblue

Member
Messages
4
Joined
Mar 25, 2017
Reaction score
0
Points
1
Hi All
Set up:
Vu+ Uno 4k
Enigma2
Openvix
Motorised

I have a couple of problems following trying to update channel list after a period of not using the stb

1. With the old .xml, I can tune all sats (53E to 30W) using usals, however no matter how many times i try it wont tune anything or show a signal for 13E!

so I generated a new .xml from the usual provider and uploaded into \etc\tuxbox

2. When retuning using the new .xml nothing will tune, no signal etc.., and I have noticed the the transponders seemed to have gained 2 extra 00s on the end.

Any thoughts??

Regards
 

DirtyDonki

Staff member
Admin
I am the Nice One
Messages
26,066
Joined
Sep 10, 2014
Reaction score
3,912
Points
728
Backup your settings and then try a ready made channel list (vhannibal coz it has it all)and see if that works for you. If it does then replace your satellite.xml file with the one from the ready made set and re-upload your own set.
 

borderblue

Member
Messages
4
Joined
Mar 25, 2017
Reaction score
0
Points
1
Thx for getting back Dirt.

This is so bizarre

Downloaded xml from vh and loaded into \etc\tuxbox so its the only .xml in the folder, tested by tuning 28.2E, 16E, 19.2E 21.5E, 9.0E all tuned fine.

Then tried 13E - no joy, scanned every transponder not one single channel.

What is going on?

Regards

Martin
 
Top Bottom