What's new

Hardware Support Problem with Selfsat H30 over Diseqc

michaelpop84

Member
Messages
3
Joined
Jun 11, 2016
Reaction score
0
Points
3
Hi there,

I had until 2 weeks ago a 80cm dish with a Multifeed and 3 Inverto ultra LNB's - 1W, 13E and 19.2E. The whole in a 4/1 Diseqc switch (EMP-Centauri Diseqc 2.0 S4 / 1PCN-W1).
I've moved, and Astra 19.2 is through a tall tree... 13E has no obstacle as the tree doesn't cover it, and 1W also clear. So I had to convert: 13E and 1W remained on the old dish, for 19.2 the neighbor was so nice and let me install a discrete Selfsat H30. I wanted to bring the 2 LNB's which remained on the old dish into port A and B of the Disecq switch, and the LNB of the second dish into the port C, instead of the third LNB from the dish. But then the problem began:

- if I have connected in the Diseqc switch only 1W and 13E, they work perfectly (about 70% signal each)
- if I have connected in the Diseqc switch only 19.2E, it works perfectly (about 75% signal)
- if I had connected in the Diseqc switch 1W and 13E and a channel of eg 1W or 13E runs, and I connect the cable of 19.2E into the switch, the channel of 1W continues normal. If I select a channel from 19.2E it is zipped normally, but if I want to switch back to a channel of 1W or 13E, 0% signal appears. Turning back to a channel of 19.2E works again, turning to a channel of 1W or 13E again not. If I disconnect the cable of 19.2E, the channels of 1W and 13E start running again.

My question is ... why can't 1W and 13E switch back after 19.2E was switched/activated? Does Selfsat H30 have any problem with the Diseqc switch, or ...?

Thanks in advance for your assistance!
 

Top Bottom