VU+ PC Tools & Editor Support Problems with DCC & Windows 10

Discussion in 'PC Tools & Editor Support' started by DirtyDonki, Jan 22, 2016.

Share This Page

Thread Status:
Not open for further replies.
  1. tappari

    tappari Member

    Messages:
    6
    Likes Received:
    2
    Try DCC 1.41
     
    • Winner Winner x 1
  2. DirtyDonki

    DirtyDonki I am the Nice One Staff Member Admin

    Messages:
    25,181
    Featured Threads:
    56
    Likes Received:
    1,802
    Done to death. Answered so many times already.

    :closed:
     
  3. Nutty

    Nutty Member

    Messages:
    9
    Likes Received:
    2
    I have just downloaded version 2.96 and after a minute or two it keeps freezing - I cant even close it down without switching the lap top off. The IP addresses are all correct and it seems to connect ok to the Solo2 fine but it does not to the router (I don't believe this is that important though). At the bottom it says FTP and telnet connected (green squares) but as I mentioned it just freezes and I can't do anything. In the protocol section there is nothing in there (I believe it should say Enigma 2 connected or something like that?). I suspect I have done something wrong somewhere but I was just wondering if this is a known problem. I am using Tens Open Vix back up 5.0-024 for the solo2.
     
  4. majz

    majz Special Friend Image Backup Specialist Donating Member

    Messages:
    361
    Featured Threads:
    13
    Likes Received:
    160
    Try using a different image like openpli 6.2 and see if it works, I had the same problem with open vix and openatv but since using openpli no problems.
     
    • Thank You Thank You x 1
  5. DirtyDonki

    DirtyDonki I am the Nice One Staff Member Admin

    Messages:
    25,181
    Featured Threads:
    56
    Likes Received:
    1,802
    • Thank You Thank You x 1
Loading...
Similar Threads
  1. basilico
    Replies:
    0
    Views:
    172
  2. benali
    Replies:
    19
    Views:
    2,119
  3. naszdom
    Replies:
    4
    Views:
    493
  4. ambulant
    Replies:
    4
    Views:
    329
  5. Bazzy
    Replies:
    0
    Views:
    238
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice