What's new

Dish & Motor Support Satellite Setup

hawkeagle

Member
Joined
Aug 23, 2019
Messages
4
Points
1
Hi Guy's,
Can you please help? I have a motorised system using my old Spiderbox. All satellite's, 28E 23E. 19.E. 13E, 1.Thor and 33W Hispasat are all available on my current setup. If I plug my new VU+ UNO 4K SE in to the same dish how do I configure the VU+Uno to use the already set up satellites locations.; I use usals for now but I do have my location available if that would make it easier,
 
Last edited:

jenseneverest

Vuplus-Images Elite
Member
Joined
Oct 18, 2014
Messages
56
Points
18
continue to use usals on the new box
You will need to have your location co-ordinates when setting up the tuner
 

hawkeagle

Member
Joined
Aug 23, 2019
Messages
4
Points
1
Can you please help me with setting up? How do I steer the dish and store the satellite positions etc and scan each satellite and store the channels usin my new box??
 

jenseneverest

Vuplus-Images Elite
Member
Joined
Oct 18, 2014
Messages
56
Points
18
that is not needed with usals.
All you need is the tuner setup for your lat and long and motorised / usals set up under the tuner configuration.
A channel list installed
Then select a channel on whatever sat and the dish will go where required when changing channels.
Simples.
 

hawkeagle

Member
Joined
Aug 23, 2019
Messages
4
Points
1
that is not needed with usals.
All you need is the tuner setup for your lat and long and motorised / usals set up under the tuner configuration.
A channel list installed
Then select a channel on whatever sat and the dish will go where required when changing channels.
Simples.
Thank you, but this is NOT a step by step guide!! You know your way around the box. Someone had to help you at first. This is new to me, the instructions are useless and so far all I am getting is bit of info that often contradict each other so I guess I might as well send it back as no one is prepared to actually offer some real help.
 

Ten Below

Staff member
Admin
Joined
Sep 9, 2014
Messages
8,068
Points
628
Location
@vuplusimages
Website
vuplus-images.co.uk
Thank you, but this is NOT a step by step guide!! You know your way around the box. Someone had to help you at first. This is new to me, the instructions are useless and so far all I am getting is bit of info that often contradict each other so I guess I might as well send it back as no one is prepared to actually offer some real help.
Simple Tuner Setup - ALL E2 Receivers
 

hawkeagle

Member
Joined
Aug 23, 2019
Messages
4
Points
1
I have a motorized system that I wish to connect to my "NEW" VU+Uno4KSE box. I have installed "Blackhole" on it and that is as far as I can get. I have entered my position and plugged it into the dish pointing at 19E. Here the story ends. With NO proper instruction's I have no way of muddling my way through all the variable settings. Can anyone direct me to a "FULL" set of instruction's as to how to set this box up from scratch?
 

Top